11 34 560 Replacing all valve stem seals (N54, N54T)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks:

Remove CYLINDER HEAD .
Remove INTAKE CAMSHAFT .
Remove EXHAUST CAMSHAFT .
Remove ROLLER CAM FOLLOWER .
Remove all VALVE SPRINGS .

Firmly press special tool 11 1 480 onto old valve stem seals.

Detach valve stem seal from valve stem by turning and simultaneously pulling special tool 11 1 480 .

Installation note:

Insert all VALVES .

Fig 1: Removing Valve Stem Seal Using Special Tool (11 1 480)

NOTE: For use on the N54 engine, special tool 11 6 380 must be remachined according to the sketch with a 10 mm drill bit dia. to a depth of B = approx. 23 mm.

This modification has already been taken into account for reordering.

Fig 2: Identifying Special Tool (11 6 380) Marking Dimension

IMPORTANT: Different diameters at valve stem.
All valve stem seals are colour-coded.

Valve dia. 5 mm: valve stem seal is red or brown.

Valve dia. 6 mm: valve stem seal is green or light green.

Fig 3: Identifying Valve Stem Seals (Red/Green)

Installation note:

Fit the mounting sleeves (plastic sleeves) supplied in the spare part on the valve stem end

Lubricate mounting sleeve.

Fig 4: Pressing Valve Stem Seal Using Special Tool (11 6 380)

Press on valve stem seal with special tool 11 6 380 by hand up to stop.

NOTE: Graphic shows N46.

Assemble engine.