11 00 Mounting engine on assembly stand (N54, N54T)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

00 2 300
11 8 541
11 8 542

IMPORTANT: Aluminium screws/bolts must be replaced each time they are released .
Aluminium screws/bolts are permitted with and without
colour coding (blue).

For reliable identification:

Aluminium screws/bolts are not magnetic .

Jointing torque and angle of rotation must be observed without fail (risk of damage) .

Necessary preliminary work:

Remove ENGINE

Use special tool 11 8 541 to mount engine on special tool 00 2 300 .

Mount engine or engine block with special tool 11 8 542 on 11 8 541 .

Fig 1: Mounting Engine Block Using Special Tools