11 00 670 Securing engine in installation position (N54, N54T)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

00 6 100
00 6 050
00 6 130

WARNING: Danger of injury!
Observe following instructions relating to special tool:

Prior to each use, check the special tools for defects, modifications and operational reliability.
Damaged/modified special tools must not be used!
No changes or modifications may be made to the special tools!
Keep special tools dry, clean and free of grease.

IMPORTANT: Before lifting the engine, check the lifting lugs for damage (cracks) and to ensure they are seated securely.

NOTE:

NUMBERING SYSTEM FOR SPECIAL TOOLS has been re-encoded.

Necessary preliminary tasks:

SECURE THE ENGINE COMPARTMENT LID IN THE SERVICE POSITION .

Fig 1: Assembling Cross Member (00 6 100) With Rests And Adapters (00 6 130)

Assemble cross-member 00 6 100 with rests 00 6 050 in conjunction with adapters 00 6 130

Supplement cross-member with feet 2 293 876 at front and 2 293 877 at rear.

Fig 2: Supplementing Cross Member

Graphic N20

Remove rubber plugs (1) on left and right sides.

Fig 3: Identifying Engine Rubber Plug

Graphic N20

When fitting the cross-member, make sure the bolt of foot 2 293 876 is secured in opening (1).

IMPORTANT: Risk of damage!
Position cross-member 00 6 100 with a 2nd person help on designated areas (1,2) of side wall.

Fig 4: Identifying Engine Opening

The contact points (1, 2) on the right side are shown.

Make sure the bolt is secured at contact point (1).

Fig 5: Identifying Contact Points (Right Side)

Screw in towing hook (1).

Fig 6: Identifying Towing Hook

Tighten down all the cross-member connections.

Suspend chain (1) from towing hook (2) and light pre-tension with spindle (3).

Fig 7: Suspending Chain From Towing Hook

IMPORTANT: Avoid a change of engine position in the transverse or longitudinal direction.
Always make sure there is sufficient clearance between the engine (or its add-on parts) and the body.

Unscrew nuts (1).

Raise engine approx. 10 mm with cross member.

Installation note:

Replace self-locking nuts.

Tightening torque 22 11 2AZ .

Fig 8: Identifying Cross Member Nut

02 1111 engine block

Content not available at website