27 21 030 Replacing radial shaft seal for output to the front axle (ATC 35L)

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2014 BMW Alpina B7L xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

After completion of work, CHECK OIL LEVEL .

Use only the APPROVED OIL in this transfer box.

Failure to comply with this requirement will result in serious damage to the transfer box!

Necessary preliminary tasks:

Remove rear UNDERBODY PROTECTION .
Remove left holder for underbody protection.

Release screws.

Tightening torque 26 11 7AZ .

Remove front propeller shaft at output flange of transfer box and tie to one side.

Installation note:

Replace screws.

Fig 1: Locating Front Propeller Shaft Output Flange Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Lever output flange (1) out of housing with screwdriver (2).

Lever radial shaft seal out of housing with a suitable tool.

IMPORTANT: Do not damage housing.

Fig 2: Removing Output Flange From Housing Using Screwdriver

Courtesy of BMW OF NORTH AMERICA, INC.

Drive in radial shaft seal with special tool 27 1 450.

Fig 3: Installing Radial Shaft Seal Using Special Tool (27 1 450)

Courtesy of BMW OF NORTH AMERICA, INC.