26 12 011 Replacing grooved ball bearing in center mount of propeller shaft

WARNING: This page is about a different car, the 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Replace PROPELLER SHAFT CENTRE MOUNT

Press grooved ball bearing using special tool 23 1 160 out of center mount (1).

NOTE: Illustration shows E46.

Fig 1: Pressing Grooved Ball Bearing Using Special Tool (23 1 160)

Courtesy of BMW OF NORTH AMERICA, INC.

Coat rubber-coated bearing seat of center mount (2) with Circolight.

Using special tools 33 3 202/33 3 203, press new grooved ball bearing (1) into center mount (2).

NOTE: Illustration shows E46.

Fig 2: Pressing Deep Groove Ball Bearing Into Centre Mount Using Special Tools (33 3 202) And (33 3 203)

Courtesy of BMW OF NORTH AMERICA, INC.