Removal Of Side Wall Holder (Variant 2)
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
Release welded connection in area (1) and remove holder (2).
Preparation of new part:
Fit in new part.
In area of adhesive surface (1), drill a 4.2 mm dia. bore hole (2) for blind rivet N3.
Remove new part and deburr holes.
IMPORTANT:
Do not grind bonding surfaces down or off.
Installation of side wall holder:
Clean all bonding surfaces with cleaning agent R1.
Apply adhesive to bonding surface.
Install new part and rivet with blind rivet.