51 16 166 Replacing center console

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove ACTUATOR DRIVE IN STORAGE COMPARTMENT

Additionally if telephone optional equipment installed:

Remove EJECT BOX

Raise mat insert (1) with suitable tool and remove.

Fig 1: Raising Mat Insert

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove storage compartment (2).

Fig 2: Identifying Storage Compartment With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

If telephone optional equipment installed

Raise both mat inserts (1) with suitable tool and remove.

Installation:

Mat inserts (1) are installation-encoded (2). Note different diameters when installing.

Fig 3: Identifying Installation-Encoded Mat Inserts

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove storage compartment (2) from center console (3).

Fig 4: Identifying Storage Compartment, Centre Console With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove trim for drinks holder (2) and holder for drinks holder (2) from center console (3).

Fig 5: Identifying Drinks Holder With Screws

Courtesy of BMW OF NORTH AMERICA, INC.