11 24 Connecting Rods and Bearings
WARNING: This page is about a different car, the 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - CONNECTING RODS AND BEARINGS
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | ASA screw (connecting rod bolt) Connecting rod bearing cap to connecting rod. |
N52K | M8 x 47 | Replace screw. Screw washed and oiled. Jointing torque and angle of rotation must be observed without fail. Jointing torque |
20 Nm |
| Torque angle | 70 ° | ||||