28 10 020 Removing and installing or replacing combination sensor (GS7D36SG)
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
After completion of work, check oil level . .
Use only the DCTF-1 Pentosin (P/N 83 22 2 147 477).
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
Use only the DCTF-1 Pentosin (P/N 83 22 2 147 477).
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
IMPORTANT:
Read and comply with notes on ESD PROTECTION (ELECTRO STATIC DISCHARGE)
.
Necessary preliminary work
- Remove twin-clutch gearbox
- Remove clutch
Release screw (1).
Release combination sensor (2) from housing.
Disconnect connector (3).
Installation note:
Replace screw.
IMPORTANT:
Do not
where possible release cable (4) from bracket (5).
Installation note:
If bracket (5) does have to be released, replace aluminum screw (6).
Tightening torque, see 28 10 11AZ in 28 10 HOUSING WITH ADD-ON PARTS .
IMPORTANT:
To disconnect the combination sensor connector:
Press lock together in area (1) and simultaneously detach connector.
Press lock together in area (1) and simultaneously detach connector.