13 54 030 Removing and installing/sealing throttle valve assembly (N54)

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks

Switch off ignition
Remove left CHARGE-AIR DUCT

Unlock and disconnect line (1).

Unlock connector (2) and remove.

Release screws.

Tightening torque 13 54 1AZ .

Remove throttle assembly (3).

Fig 1: Locating Throttle Assembly And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Installation

Replace sealing ring (1) of throttle assembly (2).

Fig 2: Identifying Sealing Ring Of Throttle Assembly

Courtesy of BMW OF NORTH AMERICA, INC.

Installation

Check stored fault messages.

Now clear the fault memory.