12 61 280 Removing and installing/replacing oil pressure sensor (N54)
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks
- Switch off ignition
- Remove ACOUSTIC COVER
WARNING:
Scalding hazard!
Only perform this task on an engine that has cooled down.
Installation location
Oil filter housing, front left.
Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.
Unlock plug (1) and remove.
Release oil pressure sensor (2).
Tightening torque, 12 61 1AZ .
Installation:
Check engine oil level, top up engine oil if necessary.