23 21 Transmission Shafts
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - TRANSMISSION SHAFTS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Output flange | S5D 200G/S5D 250G/S5D260Z/S5D 310Z/S6S 420G | Collar nut installed with bolt cement | ||
| Pretension Release |
190 Nm | |||
| Tighten down | 120 Nm | |||
| S5D 280Z/S5D 320Z | Collar nut installed with bolt cement | |||
| Pretension Release |
170 Nm | |||
| Tighten down | 130 Nm | |||
| S5D 390Z | Collar nut installed with bolt cement | |||
| Pretension Release |
200 Nm | |||
| Tighten down | 145 Nm | |||
| GS6-37BZ/GS6-17BG | Collar nut installed with bolt cement | |||
| Pretension Release |
170 Nm | |||
| Tighten down | 120 Nm | |||
| GS6-53DZ | Collar nut installed with bolt cement | |||
| Pretension Release |
200 Nm | |||
| Tighten down | 140 Nm | |||
| GS7S47BG | Collar nut installed with bolt cement | 200 Nm | ||
| 2AZ Gear to countershaft | 265/Sport | M10 | 60 Nm |