33 41 151 Replacing left or right wheel bearing on rear axle shaft (M6)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not damage multipole impulse ring.

Fig 1: Identifying Multipole Impulse Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks:

Remove REAR WHEEL .

Loosen the collar bolt (1).

For this purpose, press the brake pedal.

Tightening torque 33 41 1AZ .

Fig 2: Identifying Collar Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Renew collar bolt (1) and compression spring (2).
- Pay attention to direction of installation of compression spring!
Keep collar bolt and spur gearing of bearing/output shaft clean and free of grease.
Follow installation note of the spur gearing.

Fig 3: Identifying Collar Bolt And Spring
Courtesy of BMW OF NORTH AMERICA, INC.
Remove BRAKE DISC .

NOTE:

Check brake pads and brake discs and renew if necessary!

Release screws.

Tightening torque 33 41 2AZ .

Remove wheel bearing.

Installation note:

Replace screws.

Fig 4: Locating Axle Shaft Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Keep contact surface (2) of wheel bearing and swivel bearing clean and free from grease; clean as needed.

Fig 5: Identifying Wheel Hub

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Note on installation must be observed without fail!

Fig 6: Installing Bearing Spur Gear

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Spur gearing of bearing (1) and output shaft (2) must be installed tooth in tooth!
Tighten collar bolt with compression spring by hand.
Check whether spur gearing is locked tooth in tooth by reciprocally rotating wheel hub/output shaft.
Tighten the collar bolt.
Tightening torque 33 41 1AZ .