LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2015 >> Z4 sDrive28i, Automatic Trans >> Repair and Diagnosis >> Collision >> Sealing & Corrosion Protection >> Collision - Body Panel Repair (E89) >> Front Lid >> 41 61 010 Removing And Installing Engine Compartment Lid (Active Pedestrian Protection AFGS)

41 61 010 Removing And Installing Engine Compartment Lid (Active Pedestrian Protection AFGS)

WARNING:

Risk of injury. 

The BATTERY EARTH LEAD must be clamped off on vehicles with AFGS active pedestrian protection!

Adhere to SAFETY INFORMATION so as to avoid a danger of injury by the actuator.

IMPORTANT: Support engine compartment lid in fully opened position with suitable apparatus.
Removal of the engine compartment lid must be carried out with the assistance of a second person.

Follow instructions on ACTIVE PEDESTRIAN PROTECTION SYSTEM .

Necessary preliminary tasks: 

Disconnect NEGATIVE BATTERY CABLE .

Release GAS PRESSURE SPRING on engine compartment lid.

Unscrew nuts (1).

Remove engine compartment lid.

Installation note: 

Install engine compartment lid at screw locations to on hinge.

Tightening torque 41 61 1AZ .

If necessary, adjust ENGINE COMPARTMENT LID .

Fig 1: Identifying Hinges Screws
G11151798Courtesy of BMW OF NORTH AMERICA, INC.
Fig 2: Identifying Wheel Arch Trim
G11151779Courtesy of BMW OF NORTH AMERICA, INC.