34 52 535 Replacing a rear pulse generator
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Necessary preliminary tasks:
- Remove rear WHEEL
- Remove rear SPLASH GUARD
- Read and comply with GENERAL INFORMATION .
Release screw (1).
Withdraw wheel speed sensor (2) from bore hole.
Installation:
Tightening torque 34 51 4AZ .
Clean bore for pulse generator and lubricate with Staburags NBU 12/K lubricating grease.
Disengage line (1) along trailing arm from holders.
Installation:
Ensure proper locking of the holders and proper seating of the line in the holders.
Open housing cover (1).
Disconnect plug connection.
Installation:
Ensure proper locking of plug connector and proper seating of rubber grommets.