34 52 525 Replacing one front pulse generator

NOTE: Read and comply with GENERAL INFORMATION .

Open plug housing (1), pull plug connection (2) out of bracket and disconnect.

Pull cable with rubber grommet out of holders (3).

Installation:

Ensure proper locking of plug connector and proper seating of rubber grommets.

Fig 1: Identifying Plug Housing, Plug Connection And Holders

Courtesy of BMW OF NORTH AMERICA, INC.

Release hexagon socket head cap screw (1) and pull wheel speed sensor (2) out of bore.

Installation:

Tightening torque 34 51 4AZ .

Clean bore for pulse generator and lubricate with Staburags NBU 12/K grease.

Fig 2: Identifying Wheel Speed Sensor And Hexagon Socket Head Cap Screw

Courtesy of BMW OF NORTH AMERICA, INC.