Removing and installing/replacing fan cowl with electric fan (S63 B44 T 2) (X5 M)

Necessary preliminary taste: 

• Read out the fault memory of the DME control unit.
• Switch off ignition.
• Remove INTAKE SILENCER HOUSING .

Removal: 

Unclip Bowden cable for bonnet release and cable from transverse reinforcement.

Loosen screws (1).

Remove transverse reinforcement (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and pull off.

Detach connector (2) from fan cowl.

Courtesy of BMW OF NORTH AMERICA, INC.

Release lock (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Press lock (1).

Raise fan cowl (2) until holder (3) can be folded into center of vehicle.

Courtesy of BMW OF NORTH AMERICA, INC.

Release coolant hose (1) from the fan cowl at the bottom.

Disengage the coolant line (2) from the fan cowl.

Feed out fan cowl upwards and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Installation note: 

Insert retaining tab (1) at bottom on module carrier.

Courtesy of BMW OF NORTH AMERICA, INC.

Guide fan cowl (2) in and fold holder (3) outwards in direction of arrow.

Lock fan cowl (2) in latch mechanism (1).

Lock (1) must snap audibly into place.

Courtesy of BMW OF NORTH AMERICA, INC.

Install fan cowl.

Clip coolant hose (1) to bottom of fan cowl.

Clip coolant hose (2) to top of fan cowl.

Courtesy of BMW OF NORTH AMERICA, INC.

Lock, lock (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Attach and lock connector (1).

Connector (1) must engage audibly.

Secure connector (2) to fan cowl.

Courtesy of BMW OF NORTH AMERICA, INC.

Install transverse reinforcement (2).

Parts:  Replace screws.

Tighten down screws (1).

Tightening torque 17 10 4AZ .

Clip Bowden cable for bonnet release and cable onto transverse reinforcement.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install INTAKE SILENCER HOUSING .