Replacing one front pulse sensor (X5 M)

IMPORTANT: Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD protection).

Necessary preliminary tasks:

Disengage cable guides (2).

Open connector housing (1), pull plug connection out of holder and disconnect.

Pull cable with rubber grommet out of brackets (3).

Installation note:

Ensure proper locking of plug connection and proper seating of rubber grommets.

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage cable guides (1).

Release Torx socket (2) and pull out pulse sensor (3) from bore hole.

Installation note:

Tightening torque 31 51 3AZ .

Clean bore for pulse sensor and lubricate with Staburags NBU 12/K lubricating grease.

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Check sensor head prior to installation for external damage, replacing if necessary.