Replacing both Bowden cables for parking brake (X5 M)

Attention! 

Read and comply with GENERAL INFORMATION .

Bowden cables may only be replaced in pairs.

Observe SAFETY INFORMATION on raising the vehicle.

Necessary preliminary work: 

• Remove the ACTUATOR UNIT INCLUDING CONTROL UNIT FOR THE ELECTROMECHANICAL HOLDING BRAKE .

Bowden cable, left: 

Release union nut (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Tightening torque 34 41 5AZ .

Pull Bowden cable (1) out of actuator unit (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Attention! 

Make sure all parts are absolutely clean.

Turn spindle (1) out of actuator unit (2) and remove Bowden cable.

Installation note: 

Lubricate new spindle with grease provided.

Insert spindle (1) 3 turns into inner spline shaft of actuator unit (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Bowden cable, right: 

Release union nut (1).

Installation note: 

Tightening torque 34 41 5AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Pull Bowden cable (1) out of actuator unit (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock retaining sleeve (1) and pull out of housing a little.

Courtesy of BMW OF NORTH AMERICA, INC.

Snap out coupling (1) in direction of arrow.

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: 

• Carry out start-up/functional check in diagnosis system. 
  • Path
    • Function selection
    • Service functions
    • Chassis and suspension
    • Parking brake
    • Initial operation/function test