Removing and installing/replacing oil-level sensor for engine oil (N63 B40/B44 O1, S63 B44 T2) (X5 M)
IMPORTANT:
Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)!
.
Necessary preliminary tasks:
- Switch off ignition.
- Remove REINFORCEMENT PLATE .
- Drain ENGINE OIL .
Unlock connector (1) and pull off.
Unscrew nuts (2).
Tightening torque 12 61 2AZ .
Remove oil level sensor (3).
Installation note:
Clean sealing surface on oil sump.
Replace seal on oil level sensor.
An excessively low torque value will result in oil leaks.
An excessively high torque value will result in damage to the oil level sensor.
Top up engine oil.
NOTE:
Check stored fault message.
Clear diagnostic fault entries from fault memory.
Clear diagnostic fault entries from fault memory.