11 12 090 Removing and installing/replacing acoustic cover (N20)

Unlock and pull off vacuum connections (1) and (2) from vacuum accumulator.

Fig 1: Identifying Vacuum Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Release wiring harness (1).

Remove acoustic cover (2) in following steps:

• Lift up in the front area.
• Pull out from rear rubber guide in direction of travel.

Installation note: 

Insert acoustic cover into existing rubber guides.

Fig 2: Identifying Acoustic Cover And Wiring Harness

Courtesy of BMW OF NORTH AMERICA, INC.