51 43 070 Removing and installing/replacing side trim panel, footwell, on A-pillar, left

Special tools required: 

• 00 9 317

Necessary preliminary tasks: 

• Remove FRONT ENTRANCE COVER STRIP (INSIDE) 
• Remove trim panel for pedal assembly  . See 51 45 184 REMOVING AND INSTALLING (REPLACING) TRIM PANEL FOR PEDAL MECHANISM (ECE ONLY)  or 51 45 184 REMOVING AND INSTALLING (REPLACING) TRIM PANEL FOR PEDAL MECHANISM (US ONLY) 

Release screw (1).

Remove handle from bonnet cable release.

Release screw (2).

Carefully lever out A-pillar trim panel (1) using special tool 00 9 317 .

Disconnect plug connection behind.

Installation note: 

Neatly fit A-pillar trim (1) into door seal.

Installation note: 

Make sure A-pillar trim panel (3) is correctly seated.

If necessary, replace both clips (1) and clamp (2).

Replacement 

• Modify clips (1)
• Modify luggage compartment locking system switch
  Fig 3: Identifying A-Pillar Trim Panel, Clamp And Clip

  Courtesy of BMW OF NORTH AMERICA, INC.