51 71 345 Removing and installing/replacing left (rear) suspension cross-brace

IMPORTANT: Driving without the suspension cross-brace is not permitted! (risk of damage to the body).

Release expanding rivet (1) and remove cover (2).

Installation note:

Replace damaged expanding rivet.

Holders (3) must snap into place in suspension cross-brace when cover (2) is installed.

Fig 1: Identifying Cowl Panel Cover, Holder And Rivet

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 51 61 1AZ .

Remove suspension cross-brace (2).

Installation note:

Make sure suspension cross-brace (2) is in correct installation position.

Replace screws (1).

Fig 2: Identifying Suspension Cross-Brace With Screws (51 71 345)

Courtesy of BMW OF NORTH AMERICA, INC.