51 16 041 Removing and refitting/replacing protective cap on left or right exterior mirror (without surround view) (to 07/13)

Necessary preliminary tasks:

Insert the screwdriver (1) on the outside of the latch mechanism.

Place the screwdriver (1) on the bridge (2) and press in direction of arrow. This will release the stop for latch mechanisms (3).

Pull the protective cap evenly to the outside.

Fig 1: Inserting Screwdriver On Latch Mechanism

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Latch mechanisms (1) and guide (2) on housing (3) must not be damaged or missing.

Fig 2: Identifying Mirror Latch Mechanisms, Guide And Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Fixtures (1) on retaining plate (2) must not be missing or damaged.

Fig 3: Identifying Mirror Fixtures And Retaining Plate

Courtesy of BMW OF NORTH AMERICA, INC.