LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2015 >> M235i 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Steering And Wheel Alignment - Repair -- F23 >> Steering Wheel For Airbag >> 32 34 030 Removing and installing/replacing airbag unit (sport steering wheel)

32 34 030 Removing and installing/replacing airbag unit (sport steering wheel)

WARNING: Observe the following instructions to avoid any risk of injury by the airbag unit.
  • Comply with SAFETY REGULATIONS  for handling components with gas generators.
  • Do not exert any force on the airbag unit.
  • Use only specified release tool for the airbag unit.
NOTE: Incorrect handling may result in triggering of the airbag unit and thereby cause serious injury.
IMPORTANT: STEERING WHEEL  must be replaced if airbag unit has been triggered!
Follow PROCEDURE AFTER AIRBAG DEPLOYMENT .

Necessary preliminary tasks: 

Insert Torx screwdriver T20 (1) vertically into the concealed opening until limit position (2) can be felt.

Pull Torx screwdriver (1) approx. 2-3 mm out of opening. Press screwdriver handle carefully towards middle of steering wheel and simultaneously slide into opening in order to position the Torx screwdriver behind retaining spring bracket (refer to Fig 1 below).

IMPORTANT: Press Torx screwdriver carefully towards the middle of steering wheel and slide it in again! Pushing the Torx screwdriver too much further in the direction of steering wheel center will lead to damage of the steering wheel trim/the steering wheel.
Fig 1: Inserting Torx Screwdriver T20
G10095560Courtesy of BMW OF NORTH AMERICA, INC.

Press retaining spring bracket (1) of airbag unit inwards and simultaneously pull airbag unit upwards until it unlocks.

Repeat procedure on other side.

Installation note: 

Carefully push airbag unit in direction of steering column shaft into steering wheel with uniform pressing force until airbag engages noticeably and audibly.

Fig 2: Pressing Retaining Spring Bracket
G10095561Courtesy of BMW OF NORTH AMERICA, INC.
WARNING: Danger of injury!
The airbag unit may only be set down with the airbag itself facing up  .

Tilt airbag unit forwards.

Disconnect plug connections(1) and remove airbag unit.

Installation note: 

Make sure electrical leads are correctly positioned.

Fig 3: Identifying Airbag Unit Plug Connections
G10095557Courtesy of BMW OF NORTH AMERICA, INC.