12 14 650 Replacing suction pressure sensor on intake plenum (N20, N26)

Necessary preliminary tasks:

Unlock connector (1) and remove.

Unfasten screws (2).

Tightening torque 13 62 5AZ .

Pull out the vacuum pressure sensor (3) from the intake plenum.

Fig 1: Identifying Vacuum Pressure Sensor, Connector And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check sealing ring for damage. Replace damaged sealing ring.

When installing, coat sealing ring with suitable lubricant.

Fig 2: Locating Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Reassemble the vehicle.
Check stored fault message.
Delete fault memory.