12 14 524 Replace pulse sensor on exhaust camshaft (N20, N26)

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary : preliminary tasks:

Unlock connector (1) and remove.

Release screw (2).

Tightening torque 13 62 1AZ .

Remove pulse sensor.

Check gasket, renew damaged gasket.

Fig 1: Identifying Connector And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault message.
Clear diagnostic fault entries from fault memory.