65 77 755 Removing and installing (replacing) front passenger seat sensor

WARNING: Note AIRBAG SAFETY REGULATIONS !
Incorrect handling can activate airbag and cause injury.

Necessary preliminary tasks:

Unlock connector housing (1 to 3) and pull out of connector housing (4) in direction of arrow.

Installation note:

Connectors are encoded against incorrect assembly.

Make sure installation sequence of connector housing (1 to 3) is correct.

Fig 1: Pulling Connector Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Fig 2: Identifying Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release latch mechanism (1) in marked area.

Remove sensor (2).

Installation note:

Make sure sensor (2) is correctly fitted.

Fig 3: Identifying Latch Mechanism In Marked Area

Courtesy of BMW OF NORTH AMERICA, INC.