61 36 605 Removing and installing/replacing relay for fan control

WARNING: Observe SAFETY INFORMATION for handling vehicle battery.

Necessary preliminary tasks:

NOTE: Graphics shown on the F20 by way of example, deviations in detail are possible in other models.

Turn locks (1) 90° counterclockwise.

Unlock catch (3).

Remove cover (2).

Fig 1: Fan Control Relay Locks, Catch And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release latch mechanism (arrow) and pull relay carrier (1) up and out of power distribution box (2).

Fig 2: Relay Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Release latch mechanism (1) from relay carrier (2) and pull relay (3) off of relay carrier (2).

Installation note:

Ensure that relay carrier (2) and relay (3) are properly engaged.

Fig 3: Pulling Relay

Courtesy of BMW OF NORTH AMERICA, INC.

For hot-climate version:

Unfasten plug connection (1) and disconnect.

Release nuts (2) and attach cable to the side.

Tightening torque: 61 21 1AZ .

Loosen screws on relay (3) and remove relay.

Tightening torque: 61 36 1AZ .

Installation note:

Ensure that cable (2) and relay (3) are screwed on properly.

Fig 4: Relay Screws

Courtesy of BMW OF NORTH AMERICA, INC.