51 24 004 Adjusting rear lid lock

Special tools required:

Prerequisite:

Rear lid must be correctly adjusted to fit; if necessary, ADJUST REAR LID .

For ideal adjustment, refer to Body gap dimensions.

Completely screw in stop pad (1) left/right.

Fig 1: Stop Pad

Courtesy of BMW OF NORTH AMERICA, INC.

Lift out covers (1) using special tool 00 9 322 .

Fig 2: Lifting Covers Using Special Tool (00 9 322)

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken screws (1) until striker (2) can still just be moved and centers itself.

IMPORTANT: Striker (2) must not brush against rear lid lock.

Fig 3: Striker And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Close rear lid.

Check gap dimensions and locking comfort.

If necessary, repeat procedure.

NOTE: When the tailgate is closed, the striker must not touch or scrape against the rear lid lock. Look out for scratch marks.

Open tailgate.

Tighten down screws (1).

Tightening torque: 51 24 2AZ .

Fig 4: Striker And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Screw out stop pad (1) left/right until they are in contact with the tailgate.

It must be possible to pull out paper strips with moderate friction resistance between the tailgate and stop pad (1).

Then screw out stop pad (1) one-half rotation further.

Fig 5: Stop Pad

Courtesy of BMW OF NORTH AMERICA, INC.