51 23 211 Removing and installing/replacing pull cable for hood/bonnet locks at front

Necessary preliminary tasks:

Remove left/right engine compartment lock . See 51 23 100 REMOVING AND INSTALLING/REPLACING RIGHT ENGINE COMPARTMENT LID LOCK or 51 23 110 REMOVING AND INSTALLING/REPLACING LEFT ENGINE COMPARTMENT LID LOCK .

Unclip clutch housing Bowden cable (1) at marked points.

Installation note:

Clips must not be damaged.

To open up clutch housing cover, lever up cover (2) in direction of arrow.

Fig 1: Removing Clutch Housing Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Feed rear Bowden cable (2) out of holder (1) and clutch housing (3).

Fig 2: Bowden Cable, Holder And Clutch Housing

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Depending on the version, two variants of the Bowden cable are possible.
Version 1 : Bowden cable rear intake silencer housing
Version 2 : Longer Bowden cable stored in the cross member

Version 1:

Release Bowden cable (1) on holder (2).

Feed out Bowden cable (1).

Replacement:

If a longer Bowden cable (1) installed, the Bowden cable must be installed as described in Option 2.

Fig 3: Bowden Cable On Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Version 2:

Release Bowden cable (1) on holder (2).

Feed out Bowden cable (1).

NOTE: When converting from version 1 to version 2, the holder (2) must be retrofitted.

Fig 4: Releasing Bowden Cable On Holder

Courtesy of BMW OF NORTH AMERICA, INC.