24 11 Transmission housing, transmission oil sump
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2019 BMW M6 Gran Coupe, 2019 BMW 650i Gran Coupe xDrive, 2019 BMW 650i Gran Coupe, 2019 BMW 640i Gran Coupe xDrive, and 2019 BMW 640i Gran Coupe. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - TRANSMISSION HOUSING AND TRANSMISSION OIL SUMP
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Transmission oil sump | GA6HP19Z/GA6HP26Z/GA6HP32Z | M6 | 10 Nm | |
| 2AZ Oil drain plug | GA6HP19Z/GA6HP26Z/GA6HP32Z/GA8HP45Z/GA8HP50/GA8HP70Z/GA8P70H/GA8P75H/GA8HP75Z | M16x1.5 M24x1 M18x1 | Plastic oil sump | 8 Nm |
| S63 GA8HP75Z | 12 Nm | |||
| 3AZ Oil filler plug | GA6HP26Z/GA6HP32Z | M30x1.5 | 80 Nm | |
| GA6HP19Z/GA6HP26Z/GA6HP32Z/GA8HP45Z/GA8HP50/GA8HP70Z/GA8P70H/GA8HP75Z/GA8HP90Z/GA8P75H/GA8P75HZ | M18x1.5 | Setpoint torque Calculation of adjusting torque: see: REPAIR INSTRUCTIONS | 35 Nm | |
| 4AZ Transmission oil sump | GA8HP45Z/GA8HP50/GA8HP70Z/GA8P70H/GA8HP75Z/GA8HP90Z/GA8P75H/GA8P75HZ | M6 | Replace aluminium screws; jointing torque and angle of rotation must be observed without fail. 1. Jointing torque 2. Angle of rotation |
4 Nm 45 ° |
| Steel screws | 10 Nm | |||
| 5AZ Oil drain plug | GA8HP90Z | M10 | 12 Nm | |
| 6AZ Heat shield on gearbox | GA8HP45Z/GA8P70Z/GA8P75H | M8 | 19 Nm | |
| GA8HP45Z | M6 | 8 Nm | ||
| 7AZ Ground strap to body and transmission | GA8HP45Z/GA8HP50/GA8HP70Z/GA8P70H/GA8HP75Z/GA8P75H | M8 | 19 Nm |