17 11 035 Removing and installing/replacing fan cowl with electric fan (N55 hybrid)

WARNING: High-voltage system - danger to life!

WARNING: The following points must be strictly observed prior to starting work:

Necessary preliminary tasks:

Release screw (1) on fan cowl.

Tightening torque 17 10 4AZ .

Detach charge-air duct (2) from fan cowl.

Fig 1: Identifying Charge Air Duct And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect connector (1) on fan cowl on right.

Fig 2: Identifying Fan Cowl Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip fan cowl (1) at clamps (2) on left and right, thread out in upward direction and remove.

Fig 3: Removing Fan Cowl

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Insert retaining tab (1) at bottom on module carrier.

Fig 4: Identifying Module Carrier Retaining Tabs

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault message.

Reassemble the vehicle.

Delete fault memory.