52 25 405 Replacing left or right rear seat cover
Special tools required:
Necessary preliminary work:
- Remove LEFT OR RIGHT REAR SEAT
Lever out cover welt in marked area.
Disconnect all cable straps from wiring harness.
Installation note:
Replace defective cable straps.
Release all clamps in marked areas.
Detaching cover and upholstery:
- Release all clamps in designated areas
- Remove seat cover from upholstery
- Remove all remaining clamps from seat cover and/or upholstery
Replacing cover:
- Pull all trim wires out of seat cover
- If necessary, cut in mounting for trim wires of new cover
- Push trim wires into new seat cover
Installation note:
Bend new clamp (2) closed with pliers 52 0 050 .
- Upholstery
- Clamps
- Trim wire in seat cover
- Trim wire in upholstery
- Seat cover