52 25 030 Removing and installing complete armrest for rear seat backrest

NOTE: Sliding blocks (1) are spring-mounted.

Press sliding blocks (1) on left and right inwards and tilt cover forwards.

Fig 1: Pressing Sliding Blocks On Left And Right

Release screws (1).

Tightening torque 52 25 01AZ .

Lever out armrest towards front.

Fig 2: Identifying Rear Seat Backrest Armrest Screws

Unlock plug connections (1) and disconnect.

Installation:

Plug connections (1) are coded against incorrect installation.

Fig 3: Identifying Plug Connections