52 14 040 Removing and installing/replacing outer cover on left or right front seat

1. Unclip front cover in marked area.
2. Unclip cover in marked area from operating unit.
3. Unclip centre cover in marked area.
4. Remove the cover backward from the seat mechanism.

Fig 1: Removing Cover Backward From Seat Mechanism

Catches and guides in marked area must not be damaged.

Replace facing panel if necessary.

Fig 2: Identifying Catches And Guides In Marked Area

If necessary, move seat fully forwards and upwards.

Remove trim:

1. Unclip at rear towards top side
2. Pull on belt opening to one side
3. Bend trim open slightly at top and bottom on actuating unit
4. Bend open slightly at top and bottom and pull outwards a little

Fig 1: Removing Trim

Installation: 

Retaining clips must not be damaged.

Fig 2: Identifying Retaining Clips