51 16 282 Removing and installing/replacing left or right lower housing section (up to 07/12)

Necessary preliminary work:

Release screws (1).

Pull off lower housing section (2) towards rear.

Installation note:

Make sure lower housing section (2) is correctly seated in area (3).

Fig 1: Identifying Lower Housing Section And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Version with exterior mirror camera:

Release screw (1) and feed out holder (2).

Installation note:

Small image with view of rear.

Holder (2) must be correctly seated in guides (3).

Fig 2: Identifying Screw, Holder And Guides

Courtesy of BMW OF NORTH AMERICA, INC.

Fold exterior mirror (1) back.

Lift protective cap (2) downwards over latch mechanism (3).

Feed protective cap (2) in direction of arrow out of exterior mirror (1).

NOTE: Protective cap (2) must be bent slightly during removal.

Fig 3: Feeding Protective Cap

Courtesy of BMW OF NORTH AMERICA, INC.