51 23 220 Removing and installing/replacing Bowden cable for engine compartment lid at rear

WARNING: Scalding hazard!
Only perform work after engine has cooled down.

Necessary preliminary tasks:

Unclip clutch housing Bowden cable (1) at marked points.

Fig 1: Removing Clutch Housing Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out clutch housing cover (3) in direction of arrow and fold back.

Feed rear Bowden cable (2) out of sliding block (1) and clutch housing (3).

Fig 2: Identifying Clutch Housing Cover, Rear Bowden Cable And Clutch Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Footwell area, driver's side:

Lever Bowden cable (1) out of actuator for unlocking engine compartment lid (2).

Fig 3: Identifying Bowden Cable And Engine Compartment Lid

Courtesy of BMW OF NORTH AMERICA, INC.

Pull Bowden cable (1) out of bulkhead penetration (2).

Installation:

Make sure Bowden cable (1) is correctly laid.

Fig 4: Identifying Bowden Cable And Bulkhead Penetration

Courtesy of BMW OF NORTH AMERICA, INC.