51 23 211 Removing and installing/replacing pull cable for hood/bonnet locks at front
Necessary preliminary tasks:
- Remove top rear connection. See REPLACING THE TOP REAR CONNECTION (CONNECTION OF BOTH WHEEL ARCHES AT FRONT) .
Unclip clutch housing Bowden cable (1) at marked points.
Installation note:
Clips must not be damaged.
To open up clutch housing cover, lever up cover (2) in direction of arrow.
Feed rear Bowden cable (2) out of sliding carriage (1) and clutch housing (3).
NOTE:
Shown removed here for purposes of clarity.
Pull back retaining spring from release lever (1).
Feed Bowden cable (2) out of release lever (1) and catch carrier (3).
Repeat procedure on second bonnet lock.
Unthread cable for bonnet locks and remove.