51 12... Replace trim strip of the rear bumper panel (M aerodynamic package)

Special tools required:

Removal:

NOTE: Trim strip (1) has been bonded to the bumper panel with double-sided adhesive tape.

Carefully heat up the trim strip (1).

Carefully loosen the trim strip (1) from the bumper panel with special tool 00 9 325 .

Fig 1: Loosening Trim Strip From Bumper Panel With Special Tool (00 9 325)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clean adhesive area on the bumper panel (1).

Loosen liner from adhesive tape (2).

Position trim strip (3) over the guide pin on the bumper panel (1) and apply.

Fig 2: Positioning Trim Strip Over Guide Pin On Bumper Panel

Courtesy of BMW OF NORTH AMERICA, INC.