21 51 500 Removing And Installing Or Replacing Clutch Release Bearing/Lever

NOTE: (gearbox removed)

Do not disassemble the release module. Otherwise there is a risk of the release module being incorrectly reassembled.

NOTE: Release bearing (1) and release lever (2) have been combined to form a single release module.

Do not grease sliding surfaces.

Fig 1: Bearing And Release Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Image A: Cam (1) of release bearing (A=12 mm) is on sliding surface of release lever.

Type: N43, N45, N46

Image B: Cam (1) of release bearing (A=7 mm) is on sliding surface of release lever.

Version for all other engines

Fig 2: Release Bearing Cam On Sliding Surface Of Release Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Remove release module (1) from spring wire clip.

Remove release module.

NOTE: Similar to graphic.

Fig 3: Removing Release Module From Spring Wire Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check spring wire clip (5) and ball pin (6) for damage and replace if necessary.

Apply a thin coating of grease to ball pin (6).

Grease, refer to OPERATING FLUIDS .

NOTE: Similar to graphic.

Fig 4: Spring Wire Clip And Ball Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Clean guide sleeve (7).

Installation note:

Do not grease guide sleeve.

IMPORTANT: If guide sleeve is greased, the release lever can stick on the guide sleeve.

NOTE: Similar to graphic.

Fig 5: Guide Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.