22 11 011 Replacing left engine mount (N57)

Necessary preliminary tasks: 

• Secure engine in INSTALLATION POSITION
• Remove rear underbody protection  . See 51 47 490 REMOVING AND INSTALLING/REPLACING UNDERBODY PROTECTION (FRONT) or 51 47 491 REMOVING AND INSTALLING/REPLACING REAR UNDERBODY PROTECTION
• Release ENGINE SUPPORT ARM 

Detach vacuum hose (1) from engine mount.

Release screws (2) and remove engine mount.

Tightening torque 22 11 1AZ .

Fig 1: Identifying Vacuum Hose And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Rubber part (1) of engine mount must point to center of vehicle.

Fig 2: Identifying Rubber Section Of Engine Mount

Courtesy of BMW OF NORTH AMERICA, INC.