32 41 314 Replacing Suction Line For Power Steering (From Fluid Reservoir To Connecting Piece)
WARNING:
DANGER OF POISONING
if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.
Close off line connections with seal plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable expansion tank.
Necessary preliminary work:
- Draw off and dispose of hydraulic fluid from oil reservoir.
- Remove oil reservoir from body. See 32 41 250 REMOVING AND INSTALLING/REPLACING FLUID RESERVOIR FOR HYDRAULIC STEERING or 32 41 280 REMOVING AND INSTALLING/REPLACING OIL RESERVOIR .
- Remove RAW-AIR SUPPLY ON LEFT .
Unfasten hose clamp (1).
Disconnect intake pipe (2) from oil reservoir.
Installation note:
Marks on oil reservoir and intake pipe must match up.
Replace hose clamp.
Unfasten hose clamp (1).
Remove intake pipe (2).
Installation note:
Replace hose clamp.
Make sure intake pipe is laid without tension and with sufficient distance to adjoining components.
After installation:
- Fill and bleed hydraulic system . See 32 13 006 BLEEDING POWER STEERING (VERSION WITH DYNAMIC DRIVE) or 32 13 006 BLEEDING POWER STEERING UNIT .
- Check line connections for leak tightness.