11 61 050 Removing and installing intake plenum (N20)

Necessary preliminary tasks:

Unlock and pull off all connectors (1) from the DME control unit (2).

Release screws.

Tightening torque 12 14 1AZ .

Remove DME control unit.

Fig 1: Disconnecting Ignition Coils And Injector Wiring Harness From DME Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Press and hold lock (1) of tank ventilation line (2).

Pull off tank ventilation line (2).

Fig 2: Identifying Tank Ventilation Line And Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Detach plug connection (1) at tank vent valve (2).

Detach tank vent valve (2) from mounting.

Fig 3: Identifying Tank Vent Valve And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) on throttle valve drive.

Fig 4: Identifying Plug Connection On Throttle Valve Drive

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and remove.

Fig 5: Identifying Throttle Valve Drive Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unlock snap fastener (2).

Press charge air duct down.

Fig 6: Identifying Charge Air Duct, Snap Fastener, And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Tightening torque: 11 61 1AZ .

Release cable strap under intake plenum with a suitable tool.

Installation note:

Check all profile seals, replace if necessary.

Fig 7: Identifying Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace all gaskets.

Assemble engine.