31 51 020 Replacing radial shaft seal for output shaft, right

Special tools required :

31 5 130

Necessary preliminary work :

REMOVE right output shaft.

Lift out radial shaft seal (1) from the bearing support (3) with a screwdriver (2).

Fig 1: Removing Radial Shaft Seal From Bearing Support

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Protective sleeve (1) serves to protect the sealing lip of radial shaft seal (2) from being damaged when the output shaft is inserted into the bearing support.

Fig 2: Identifying Protective Grommet And Radial Shaft Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note :

Drive in radial shaft seal with special tool 31 5 130 as far as it will go.

Fig 3: Driving Radial Shaft Seal Using Special Tool (31 5 130)

Courtesy of BMW OF NORTH AMERICA, INC.