51 41 000 Removing and installing (replacing) front left or right door trim panel

Special tools required:

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Necessary preliminary tasks:

IMPORTANT: Do not ever pull on the folding compartment.

Release screws (1).

Tightening torque 51 41 1AZ .

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Do not pull folding compartment. Door trim panel lower section may separate from door trim panel upper part.

Mask front door and door trim panel in working area with plastic adhesive tape.

Release door trim panel using special tool 00 9 325 in A-pillar/mirror triangle area starting at clips (1).

Pull off door trim panel from clamps (2).

Fig 2: Identifying Door Trim Panel Clamps And Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage Bowden cable (1) for release lever first at counter support (2) and then at door lock (3).

Installation note:

Perform function check for door inside handle with door open and rotary striker lock closed.

Feed out door wiring harness from all brackets.

Fig 3: Identifying Bowden Cable, Counter Support And Door Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect all plug connections, then remove door trim panel.

Installation note:

Make sure the installation location of the clips (1 and 2) is correct.

Installation note:

After assembling the door trim panel proceed as follows: