11 22 000 Removing and installing/replacing the flywheel (N47D20 K/U/O/T 1)

Special tools required: 

• 11 4 180
• 11 9 260
• 11 9 263
• 11 9 264
• 11 9 265

Necessary preliminary tasks: 

• Disconnect NEGATIVE BATTERY TERMINAL .
• Remove and install front and rear underbody protection  . See 51 47 490 REMOVING AND INSTALLING/REPLACING FRONT UNDERBODY PROTECTION or 51 47 491 REMOVING AND INSTALLING/REPLACING REAR UNDERBODY PROTECTION .
• Remove and install transmission  . See 24 00 033 REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (GA8HP45Z) N47 or 24 00 033 REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (GA8HP45Z) N47 AWD .

Manual gearbox. 

Secure flywheel with transmission bolt (1) and special tool 11 9 260 /11 9 265 .

Release flywheel studs with special tool 11 4 180 /

Tightening torque: 11 22 2AZ .

Automatic transmission. 

Secure flywheel (1) with special tool 11 9 260 /11 9 263 /11 9 264 .

Unfasten flywheel studs.

Tightening torque: 11 22 1AZ .

Assemble engine.