11 13 Oil sump
TIGHTENING TORQUE SPECIFICATION - OIL SUMP
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Oil drain plug to oil sump of all-wheel drive vehicle. | N20/N26 | M12 x 1.5 | Replace the sealing ring. | 25 Nm |
| 2AZ Oil drain plug to oil sump without all-wheel drive vehicle. | N20/N26 | M12 x 1.5 | Replace plastic screw. | 8 Nm |
| 3AZ Oil sump (plastic) to crankcase lower section. | N20/N26 | M6 x 25 | Replace screws | 10 Nm |
| 4AZ Oil sump (aluminium) to crankcase lower section (all-wheel drive vehicle). | N20/N26 | M6 x 25 M6 x 80 M6 x 120 | 10 Nm | |
| 6AZ Transmission to oil sump. | N20/N26 | M8 x 50 8.8 | 22 Nm | |
| 7AZ Oil level sensor to oil sump. | N20/N26 | M6 | 8 Nm | |
| 8AZ Oil sump (plastic) to crankcase lower section. | N20/N26 | M6x119 | Replace screws | 12 Nm |