41 00... Body Gap Dimensions

The dimensions specified in this service information are applicable at an object temperature of 20°C. The aim of adjustment is to achieve a uniform join.

Symmetry of the gaps between left and right sides of the vehicle has top priority.

The door gaps must not deviate between the front and rear door gap by more than 1.0 mm.

No gap dimensions are specified for components which cannot be adjusted.

Dimensions in mm

Fig 1: Hood, Grille, Front Fender, Front Bumper And Headlamp Body Gap Dimensions And Measurement Points

G11110645

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 2: Hood, Front Fender, Front Door And Front Pillar Body Gap Dimensions And Measurement Points

G11110646

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 3: Roof Panel And Moon Roof Body Gap Dimensions And Measurement Points

G11110647

Courtesy of BMW OF NORTH AMERICA, INC.

+ dimensions are a glass sunroof protrusion.

- dimensions are a glass sunroof short length.

Fig 4: Front Fender, Front Door, Rear Door And Side Sill Trim Body Gap Dimensions And Measurement Points

G11110648

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 5: Rear Door, Side Sill Trim, Rear Wheel Arch Cover And Quarter Panel Body Gap Dimensions And Measurement Points

G11110649

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 6: Roof Panel And Lift Gate Spoiler Body Gap Dimensions And Measurement Points

G11110650

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 7: Rear Glass, Quarter Panel, Liftgate And Rear Bumper Body Gap Dimensions And Measurement Points

G11110651

Courtesy of BMW OF NORTH AMERICA, INC.