11 22 510 Removing and installing/replacing flywheel (transmission removed - S63)
WARNING: This page is about a different variant/trim than selected.
Special tools required:
Necessary preliminary tasks:
- Remove transmission. See REMOVING TWIN-CLUTCH GEARBOX or REMOVING MANUAL TRANSMISSION .
Fix flywheel in position with special tool 11 9 260 as shown in graphic.
Release flywheel bolts with special tool 11 4 180 /
Twin-clutch gearbox:
Release all flywheel bolts (1).
Remove all special tools.
Remove flywheel (2).
Installation note:
Clean thread of flywheel bolts in crankshaft.
Flywheel (2) is secured with an alignment pin.
Fit new flywheel bolts.
Tightening torque 11 22 1AZ .